Marinas need to be sturdy and weather-resistant and should be able to withstand the elements of the sea. Marine Frontiers has a team of experienced designers who have a thorough knowledge about marina and boat construction. Our clients can avail of the most suitable design with the assurance of accurate recommendations for any type of marina / pontoon / finger / Wave Attenuator / Gangway and floating structures / piled structures.

MANUFACTURE
International quality and design by our dynamic inhouse engineers, technicians and highly skilled labour.

INSTALLATION
The team at Marina Frontiers provides ready installation for any project when and where required.

AFTER SUPPLY SERVICE Periodic checking of the marinas by our expert crew as and where required.

CONNECTIONS
Designed of bolt through semi-exible joints of rubber.

DECKING
Kiln dried, grooved hardwood at a minimum thickness of 25mm. stainless steel screw xing. Other options are available like plastic, wood, concrete and steel.

PILE GUIDES
Designed with low friction lining. Adjustable and made of the main frame of the pontoon to keep the same finish after tendering.

FASTENERS AND RELATED HARDWARE
Made of stainless steel and designed for high lateral impact load and stress relief.

FLOATS
Are made of expanded polystyrene covered with minimum 4mm elastomer or concrete. Adjustable and designed for shock absorption.
• Elastomer Encapsulated Floats
• Concrete Encapsulated Floats

FENDER
D – rubber fender wood or plastic all round pontoons, fingers and pile guides.

CLEATS/ BOLLARDS
Made of cast aluminium or fabricated 316 stainless steel, can be fitted anywhere along walkway and fingers. Double Post fabricated bollards to 10 tonne capacity are also provided.

SERVICE DUCTS
All walkways are supplied with continuous service ducts tray on one side or both sides and/or dedicated ducts within the concrete type pontoons.

FINGERS
Location is fully adjustable.

STRUCTURE
Made of welded aluminium alloy 6082 T6 or 40 Mpa Concrete with Dramix 316 SS Febie.